About the Product
Ingredients
How to Use
For a Lash Tint
*If lash lifting and tinting, the tint is applied after the setting/neutralizing step
Step 1
Dispense 2cm of tint into the ramekin.
Step 2
Dispense 15-20 drops of the oxidant into the ramekin.
Step 3
Mix well for 2 minutes. There should be no visible chunks when finished mixing.
Step 4
Apply under eye gel passover the lower lashes if not tinting the lower lashes. If you are tinting the lower lashes, place the gel pads underneath the lower lashes as close as you can get to the eye.
Step 5
Start your timer as soon as you begin applying and take no longer than 2 minutes to apply the tint. Working back and forth between both eyes, and without touching the skin, apply the tint to the entire lash and almost to the base of the lashes. Get as close as you can without touching the skin. Leave the tint on for 5-8 more minutes. If any tint is on the skin, remove it quickly.
Step 6
Remove the tint thoroughly with lightly damp cotton (not wet and no dripping). Work from the lashline and out. Avoid getting any tint on the skin. If performing a lash lift prior to the tint, use a dry applicator to remove the tint. Remove the gel pads. If any tint has touched the skin, remove it quickly.
For an Eyebrow Tint
Step 1
Dispense 2cm of tint into the ramekin.
Step 2
Dispense 15-20 drops of the oxidant into the ramekin.
Step 3
Mix well for 2 minutes. There should be no visible chunks when finished mixing.
Step 4
Start your timer as soon as you begin applying and take no longer than 2 minutes to apply the tint. Working back and forth, use an angled eyeliner brush to line the underside of both eyebrows. Clean up any smudged or messy looking areas with a micro wand. Line the arches and tails. Fill in the brow with tint and fill in the heads last for an ombre look. Clean up any messy areas and make lines clean. Leave tint on for 1-5 more minutes
Step 5
Remove the tint thoroughly with damp cotton. The eyebrows will continue to darken after the tint is removed. The tint will also lightly tint the skin.
For an Eyebrow Tint with Brow Lamination
*If performing a brow lamination, the tint is applied after the setting/neutralizing step
Step 1
Dispense 2cm of tint into the ramekin.
Step 2
Dispense 15-20 drops of the oxidant into the ramekin.
Step 3
Mix well for 2 minutes. There should be no visible chunks when finished mixing.
Step 4
Start your timer as soon as you begin applying and take no longer than 1 minute to apply the tint. Working back and forth, use an angled eyeliner brush to line the underside of both eyebrows. Clean up any smudged or messy looking areas with a micro wand. Line the arches and tails. Fill in the brow with tint and fill in the heads last for an ombre look. Clean up any messy areas and make lines clean. Leave tint on for 30 seconds-1 minute more. The brow lamination makes the tint work quickly
Step 5
Remove the tint thoroughly with dry cotton or tissue. The eyebrows will continue to darken after the tint is removed. The tint will very lightly tint the skin